Cybex / Trotter 700T, 710T Treadmill Motor Repair
Cybex, Trotter 700 Series Baldor Treadmill Motor Rebuild Includes the Following:
Models 700T, 710T
Armature testing: test for shorted windings by a bar to bar electrical resistance ohm test. Test for insulation breakdown by 1,000 volt hi-pot, and a 500 volt megger test. Check shaft for straightness.
If windings pass the above tests, the armatures’ commutator is turned, undercut and polished to return the armature to its original condition, within .002” out of round. The reconditioned armature is checked for proper balance and rebalanced if needed. If the armature windings do not pass the tests above, you will be notified if rewinding is needed as this would be an extra charge.
Magnets are checked for magnetism and chips or cracks are repaired.
Brush holders are tested for insulation leakage by 1,000 volt hi-pot and 500 volt megger tests.
Motor bearing journals are inspected and machined if needed
Bearings are replaced, Brushes are replaced
Motor reassembly and testing, Cleaning and painting
Pricing reflects cost of parts available at time of last service.
Or Call: 800-423-4789
Monday - Friday, 8:00am - 5:00pm PST